12V 100A Fleet Chgr w 100A Power Supply W/ PROMO - PL6800CL

• The PL6800 is designed to provide stable power, on demand up to 100 amps, to a vehicle electrical system to support module reprogramming. It is also designed specifically for fleet service battery charging with a maximum charge rate of 100 amps, to quickly and effectively bring 4- and 8-battery Group 31 packs back to full charge. • In power supply mode, the PRO-LOGIX PL6800 provides power to maintain vehicle electrical system voltage at a preset level, increasing its output in response to system load increases to maintain a stable power environment for successfully reprogramming. It features a voltage output range of 13.1-14.9V, adjustable in 0.1V increments. allowing the operator to dial the output in exactly as specified by the supplier of the vehicle under service. It features fast load responsiveness for ultra-quick recovery from system demand increases. It also delivers its massive power with minimal voltage ripple (<100mV), providing a clean flow of power to the vehicle without risk of programming interference. • In charging mode, the PL6800 utilizes advanced microprocessor-controlled logic to precisely deliver a fully automatic charging routine designed to optimally charge and maintain each battery or battery pack serviced. The PL6800 features the ability to properly charge a wide variety of lead acid battery types, including Conventional, AGM, Spiral Wound, Start-Stop, Deep Cycle and Marine batteries – for virtually any lead acid battery type installed in a vehicle, the PL6100 can deliver a proper, beneficial charge. The PL6800 adapts its charging approach based on the needs of each battery or battery pack it services. Such adaptations can include activating a soft start mode on deeply discharged batteries, a battery repair mode on older/distressed batteries and temperature compensation when charging in extreme temperatures. It also incorporates numerous features to make charging safer for the operator and the vehicle/battery being charged, including over-voltage protection, reverse polarity protection, smart clamp technology and battery fault detection. • 0-100A (on demand) power supply mode to maintain system voltage • Power supply mode provides optimal support for vehicle reprogramming and ADAS recalibration • Power supply mode has minimal voltage ripple (<100mV) • Power supply mode features Rapid Load Response (RLR) technology • 100/40/10A charging modes allow quick, efficient charging of all battery sizes • Properly charges Flooded, AGM, Spiral Wound, Deep Cycle and Marine Batteries • Forced start mode allows charging of totally dead batteries • Battery repair mode overcomes battery sulfation to restore reserve capacity • Reverse polarity protection and battery fault detection • Extra-long 13' cable reach • PowerJaw clamps provide improved access to hard-to-reach batteries • PowerJaw clamps allow the hood to be closed (most vehicles) during ADAS calibration • Requires 20A service • W/ PROMO 12V, 20/10/2A Intelligent Battery Charger with Engine Start Assistance AND COB LED Work Light MAX 300LM

 

SOL-PL6800CL